Description
Key features SystemSure Plus Luminometer:
- Alphanumeric location IDs.
- Dimensions (approx.): 258 g, 18x7x3 cm.
- Detects down to 1 femtomole of ATP.
- Programmable pass/fail settings.
- Stores thousands of test results.
- 250 programmable locations per sample plan.
- Battery powered (standard AA).
- Runs 1000-2000 test on 2 AA batteries/charging.
- No data loss due to battery or power failure.
- RLU results 0-9999 RLU.
- Start-up (calibration self-check): 60 sec.
- Results in 15 seconds.
- Robust (withstands drop from 1 m).
- Results shown as RLU or as symbols (pass/fail/caution).
- Warnings: low battery, memory and re-calibrate.
Rapid system for measuring biological contamination
The BioDetect system helps restoration companies, mould clean-up companies, consulting and advisory firms in building analysis (mould damages etc.), insurance companies, etc., examine the mould and bacterial contamination on water-damaged materials in a fast, accurate and cost-effective way. The biofilms that arise in connection with mould and bacterial growth on water damaged building materials can be easily detected using BioDetect system.
The primary function of the BioDetect system is to determine the level of contamination on building materials and to demonstrate the cleaning and disinfection efficacy after mould or water damage restoration.
Water damage and mould growth in buildings and homes are serious health risks. Contaminated or water damaged building materials and surfaces in buildings can cause indoor air problems that can be very difficult to identify and treat. Often the cost of tests, collection of mould samples and the actual mould remediation can be immense.
Statement of Use UltraSnap and SystemSure Plus
Mould and Bacteria Remediation and Clearance Testing – Protocol for ATP Sampling of Surfaces for Mould and Bacteria.
The BioDetect Ultrasnap ATP swabs and the BioDetect Systemsure II luminometer will be used to determine the level of surface contamination for viable biological matter, primarily bacteria and biofilms that may be present on contaminated surfaces. The purpose of the sampling is to determine the level of biological surface contamination of abated substrates, building surfaces and materials that are part of a remediation project, cleaned and disinfected building materials that are being left in place or are not being abated. The building materials suitable to be tested with the BioDetect system include, but are not limited to, wall studs (metal and wood), concrete, vinyl and ceramic tile, laminate surfaces, stainless steel, masonry materials, plastic, gypsum board or sheetrock, wood sheathing, glass, etc.
The BioDetect bio-contamination detection system is designed to evaluate the level of surface cleanliness and sanitized hygiene in the indoor environment after mould and bacteria restoration. This system will not detect specific strains of bacteria, viral or other micro-organisms, rather will measure and document the total surface where these types of organisms may be detected or harbored as a result of dirty and unhygienic conditions.
